BookTitleMAGNET_GENERAL_CATALOG_2019

Summary

MAGNET_GENERAL_CATALOG_2019

renHOLDING TOOLSModel YS WORK SUPPORTER*ELECTROMAGNETIC CHUCKPERMANENTPERMANENTCHUCKS CONTROLLERS MAGNETIC CHUCKS ELECTROMAGNETIC CHUCKSBLOCKSFOR MCVACUUMCHUCKSPROMELTA*SYSTEMNonmagnetic workpiece supporterYS-10YS-15A[mm(in)]ModelLengthDimensionsWidthThicknessMassYS-10100(3.93)100g/0.22 lb×245(1.77)4(0.15)YS-15A150(5.90)165g/0.36 lb×2※For all models, two pieces make one set.Model MV MINI V-ADAPTER■Model:MV-1■Dimensions:80(3.14)×(42)(1.65)×10(0.39)mm(in)■Mass:250 g/ 0.55 lb■Parallelism:0.006■HardenedMV-1[Application]These supporters can hold materials having weak magnetic propertiessuch as carbide and materials such as aluminum, brass and stainlesssteel which cannot be held by magnetic chucks. They are held by a strongspring force on both sides and secured to the magnetic chuck.[Features]●These supporters are thin and therefore can be used for relatively thinworkpieces.●One set consists of two supporters.WorkpieceWorkpiece supportersWorkpieceAn example of usageMagnetic chuck[Application]This adapter itself is not magnetic, but when it is placed on a V-holderhaving the N pole and S pole on separate sides like Model KVA, it inducesmagnetism to hold small diameter workpieces that cannot be physicallymounted directly. (See the figure below.) This adapter is recommended forholding workpieces during grinding, drilling and measurement.[Features]●The attractive face can be set to any angle between 90 and 180degrees.●The hinge part acts as a separator to divide magnetic poles.MV-1SINE BARCHUCKSFoldingdiNSBLOCKS, HOLDERS,MINI CHUCKS1080 (42)ctioHOLDINGTOOLSMEASURING MAGNETICTOOL HOLDERS HOLDERSMAGNETICTOOLS61Model MP MAGPAD*30330 33W31313LHMP-3M5 screws can be used to detach the Magpadfrom the workpiece.MP-2MP-1[mm(in)]ModelHoldingDimensionsPower Width Length HeightMassMP-180N( 8kgf)26(1.02)35g/0.07 lbMP-2200N(20kgf)66956(2.20)(2.59)(0.35)70g/0.15 lbMP-3250N(25kgf)86(3.38)110g/0.24 lb※The holding power is based on a test piece of SS400, 20 mm thick, ground surface.[Application]The Magpad is a device to prevent wire breakage by heatdue to aerial discharge. It protects wire electrodes of wireelectric discharge machines from scattering of coolantwhich is likely to occur at the start of discharging. ThisMagpad can also be used to prevent dislocation or fallingof cut-out pieces at the start or end of cutting.[Features]●The Magpad is made of transparent acrylic plateincorporating powerful magnets. The Magpad has strongholding power and enables it to set a wire whilemonitoring its position visually.●No mechanical clamp is required. Attaching anddetaching can be done efficiently and without a fear ofdamaging workpieces.●Various models are available to suit any workpieceshapes.●There is no fear of rusting and the magnetic force issemi-permanent. The Magpad withstands repeated useand therefore is very economical.