BookTitleMAGNET_GENERAL_CATALOG_2019

Summary

MAGNET_GENERAL_CATALOG_2019

MAGNETIC TOOLSKF-HC / KF-QELECTROMAGNETICCHUCKSModel KF-HC POWERFUL ROUND FLOATER*An example of usageφDCHUCKPERMANENTPERMANENTCONTROLLERS MAGNETIC CHUCKS ELECTROMAGNETIC CHUCKSBLOCKSFOR MCVACUUMCHUCKSPROMELTA*SYSTEMSINE BARCHUCKSBLOCKS, HOLDERS,MINI CHUCKSHOLDINGTOOLSMEASURING MAGNETICTOOL HOLDERS HOLDERSMAGNETICTOOLS89KF-HC1218[Application]Designed for separation of irregularly shaped workpieces(steel plates) that do not have a straight part of sufficientlength.[Features]●The magnetic force can be adjusted by changing theinternal magnet position.●Small but powerful.ModelKF-HC0813KF-HC1218KF-HC1424DimensionsD H h PL PW N M76.3(3.00)114.3(4.50)139.8(5.50)130.0(5.11)175.0(6.89)235.0(9.25)Model100(3.93)140(5.51)195(7.67)?65(2.55)80(3.15)Dimensions60(2.36)65(2.55)80(3.15)Model KF-Q PERMANENT ELECTROMAGNETIC FLOATER*PowersavingRectifier required additionallyKF-Q10(An example of special fabrication)An example of usage■Principle of the FloaterThe Floater induces the same type of magnetic poles in steel plates stacked opposingthe magnetic pole face to separate the plates by the repelling force of the same poles.■Floating distanceWhen a pair of Floaters are positioned on each side of stackedSplates in the longitudinal direction, the distance the top plate isNNfloated from the second one is as shown in the table.SSThis distance applies when the Floater is positioned 50 mmSSaway from the edge of plates and the initial position of the firstSplate is 50 mm below the top end of the Floater. Note, however,that if plates are warped or oil is sticking to them, the distancewill become shorter.PLMagneticfaceN-M24SourceCapacity[mm(in)]MassM 8(0.31),Approx. 2kg/Depth 10(0.39)4.4 lbM 8(0.31),Approx. 7kg/Depth 12(0.47)15.4 lbM10(0.39),Approx. 14kg/Depth 15(0.59)30.8 lb[Application]Most suitable for remote control of ON and OFF of separation of steel plates.[Features]●Compared with the electromagnetic type, this type has a widermagnetic force effective width.●Compared with the permanent magnetic cylinder changeover type thatcan be controlled remotely, this type requires much less space.●Compared with the electromagnetic type, this type consumes less electricitysince electricity is supplied momentarily only for ON/OFF operation.PW(Back)MasshH[mm(in)]ApplicableRectifierKF-Q10 W159(6.25)×D64(2.51)×H144(5.66) 1.5kVA 10kg/22.0 lb※KFQR-260A(1) Stand large plates vertically against a wall, etc. This way, you can make good use of the separating force since part of the separating force required to supportthe weight of plates can be reduced.(2) Large steel plates and plates that are stuck closely by oil or grease can be separatedeffectively by using several units of the Floater coupled.(3) When steel plates are stacked high, mount the Floater on a lilfter. (The suitable heightof the Floater is slightly higher than the top of plates.>15964422100(Magnetic range)144An example ofseparation of steel platesPermanent electromagnetic typeintroduced to FLOATER Series!A special size is available also.(1) (2) (3)FloaterSteelplatesWall orsupporterSteelplates[mm(in)]Test Plate Thickness Thickness Thickness ThicknessModel1.0 1.6 2.0 3.2SizeKF-5B18(0.70)14(0.55)10(0.39) 5(0.19)150(5.90)×450(17.7)KF-1014(0.55)12(0.47)6(0.23)?KF-2026(1.02)17(0.66)9(0.35)?300(11.8)×900(35.4)KF-3033(1.29)26(1.02)18(0.70) 7(0.27)KF-4034(1.33)28(1.10)20(0.78)10(0.39)KF-T5A5(0.19) 3(0.11)2(0.07)?80(3.15)×200(7.87)KF-T1012(0.47)10(0.39)9(0.35) 6(0.23)160(6.29)×300(11.8)KF-T20KF-S type14(0.55)?10.5(0.41)?200(7.87)×400(15.7)(Magnetic range)Patented※When the magnetization operation or demagnetization operation is performed five timessuccessively per minute on the control unit, the unit will be brought into an alarm stateand will not accept further operation for safety. To reset the alarm state, turn off thesource power once and then turn it on again.Floater lifter